Hi! I am trying to apply a calculated item to just one metric in a table and not to all of them. Basically, be able to display this (see photo attached), where I can assign no calculation to some metrics. Do you guys know how to do it?
Thank you!
Page 1 / 1
Hi Valef,
If you want the calculation to apply to a single metric rather than all metrics, you can select ‘Add metric again’ for the specific metric and then use the ‘Show value as’ option for that metric, as shown in the screenshot below :
I hope that helps !
Best,
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.